Printer Connection and Software Installation 129
• Using Non-Wizard Setup to Configure a Wireless Printer Adapter
For Mac OS X, you can configure a wireless settings only through non-wizard setup.
NOTE:
• The optional wireless printer adapter must be installed on the printer. For details about installing a wireless printer adapter,
see "Installing the Optional Wireless Printer Adapter" on page 67.
You can configure the wireless printer adapter with the following connection methods:
• WPS-PBC
• WPS-PIN
• Operator Panel
• CentreWare Internet Services
WPS-PBC
You can start Push Button Control only from the operator panel.
NOTE:
• WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register devices required for
wireless configuration by pressing the button provided on the access point via wireless routers, and then performing
WPS-PBC setting on the operator panel. This setting is available only when the access point supports WPS.
1 Press the (System) button.
2 Select Tools tab.
3 Select Admin Settings.
4 Select Network.
5 Select Wireless.
6 Select WPS Setup.
7 Select Push Button Control.
8 Select Start Configuration.
9 Ensure that the message Setting WPS is displayed, and start pressing the button on the wireless LAN access
point, within two minutes of the step 8 operation.
NOTE:
• For details about WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless LAN
access point.
When the WPS operation is successful and the printer is rebooted, wireless settings are correctly configured.
To Next Page
Loading...
Need help?
General
