148 Printing Basics
5 Slide both width guides until they rest lightly against the edge of the print media stack.
NOTE:
• Do not force the print media into the bypass tray.
6 On the prompt screen displayed on the LCD panel, specify whether to use the driver setting for the paper size
and type.
To use the driver setting, ensure that the Use Driver Settings for Print Job check box is selected
and go to step 11.
To specify the setting on the operator panel, clear the Use Driver Settings for Print Job check box
and go to step 7.
7 Select Size.
8 Select the appropriate paper size.
9 Select Type.
10 Select the appropriate paper type.
11 Select OK.
Loading Envelope in the Bypass Tray
Use the following guidelines when loading envelopes in the bypass tray:
IMPORTANT:
• Never use envelopes with windows, coated linings, or self-stick adhesives. These lead to paper jams and can cause damage
to the printer.
NOTE:
• The maximum height (quantity) of envelopes that can be loaded in the bypass tray is approximately 15 mm (0.59 inches) (15
envelopes).
• If you do not load envelopes in the bypass tray right after they have been removed from the packaging, they may bulge. To
avoid jams, press firmly across the whole envelopes to flatten them as shown below before loading the envelopes in the
bypass tray.
To Next Page
Loading...
Need help?
General
