Fujitsu PRIMERGY BX900 - Page 93

© 2011 Fujitsu Technology Solutions
Severity Level 6
Error Message policyApplyIntfConfigData: error returned from
policyIntfMcastCtrlModeApply() setting intIfNum=<intIfNum> to
mode=<mode>
Explanation Failure setting the multicast mode for an interface
Recommended Action The interface number need to be checked available by the
system.
Severity Level 6
Error Message policyApplyIntfConfigData: error returned from
policyIntfDlfCtrlLimitApply() for intIfNum=<intIfNum>
Explanation Failure setting the unicast rate limiting for an interface
Recommended Action The interface number need to be checked available by the
system.
Severity Level 6
Error Message policyApplyIntfConfigData: error returned from
policyIntfDlfCtrlModeApply() setting intIfNum=<intIfNum> to
mode=<mode>
Explanation Failure setting the unicast mode for an interface
Recommended Action The interface number need to be checked available by the
system.
Severity Level 6
Error Message Error on call to osapiFsWrite routine on config file policy.cfg
Explanation check for file saving
Recommended Action The storm control config file is corrupt instead of the factory
default.
Severity Level 6
Error Message Error on call to policyMapIntfIsConfigurable routine outside the
EXECUTE state
Explanation routine outside the state
Recommended Action The storm control config file is corrupt instead of the factory
default.
Severity Level 6
Error Message Error accessing POLICY config data for interface <intIfNum> in
policyMapIntfIsConfigurable.
Explanation verify that the configId in the config data table entry matches the
configId that NIM maps to the intIfNum we are considering
Recommended Action The storm control config file is corrupt instead of the factory
default.