Fujitsu PRIMERGY TX1320 M5 User Manual

Concluding steps
▶
"Reassembling" on page 54
.
▶
If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page 57.
▶
"Switching on the server" on page 60.
▶
"Enabling replaced components in the BIOS" on page 87.
▶
Inform the customer about changed WWN and MAC addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 93.
▶
After replacing a network controller in a server running Linux OS, see
"Updating the NIC configuration file in a Linux and VMware environment" on
page 90.
▶
"Updating expansion card firmware" on page 79.
▶
"Resuming BitLocker functionality" on page 91.
▶
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
Configuration of network settings should be performed by the
customer. For more information, see
"Note on network settings
recovery" on page 206.
▶
If applicable, restore LAN teaming configurations, see "After replacing or
upgrading LAN controllers" on page 98.
9.6
Flash backup unit (FBU)
9.6.1 Position of the FBU
The FBU backs up the memory contents of the RAID controller in the event of
a power failure. One FBU can be installed in the system.
Depending on the RAID controller, different FBUs are available. In
configurations with PRAID EP5x0i/EP6x0i, an FBU345 is required.
Expansion cards and backup units
TX1320 M5 Upgrade and Maintenance Manual 207

Fujitsu PRIMERGY TX1320 M5 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX1320 M5
Category	Server
Language	English