▶
"Switching on the server" on page 60
.
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There
is no technical problem.
Proceed as follows:
●
Restart your server.
●
As soon as the startup screen appears, press the
[F2] function key to
enter the BIOS.
●
If a password is assigned, enter the password and press [Enter].
●
Select the Save & Exit menu.
●
Select Save Changes and Exit or Save Changes and Reset.
●
Verify that the Global Error indicator stops flashing.
▶
If applicable, "Updating or recovering the BIOS and iRMC S6" on page
75
.
▶
"Resetting the error status after replacing memory modules or CPU" on
page 82.
▶
"Enabling replaced components in the BIOS" on page 87.
▶
"Resuming BitLocker functionality" on page 91.
11.4 Replacing the heat sink
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Processor (CPU)
TX1320 M5 Upgrade and Maintenance Manual 243
To Next Page
Loading...
Need help?
General