Concluding steps
▶
If applicable, install the NVMe cables from the PCIe backplane, see
Figure 85.
▶
If applicable, install the HDD fan module (2.5-inch HDD variant), see
"Installing the HDD fan module (2.5-inch HDD variant)" on page 68.
▶
If applicable, install an expansion card, see "Installing expansion cards" on
page
195.
▶
"Reassembling" on page 54.
▶
"Connecting the power cord" on page 57.
▶
"Switching on the server" on page 60.
17.6.4 Replacing an M.2 SSD
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 15 minutes
Tools: tool-less
Preliminary steps
▶
"Locating the defective server" on page 43
.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 48.
▶
If applicable, remove an expansion card, see "Removing expansion cards"
on page 203.
▶
If applicable, remove the HDD fan module (2.5-inch HDD variant), see
"Removing the HDD fan module (2.5-inch HDD variant)" on page 67.
▶
If applicable, remove the NVMe cables from the PCIe backplane, see
Figure 84.
System board and components
TX1320 M5 Upgrade and Maintenance Manual 327
To Next Page
Loading...
