Power-on/AC connected indicator (5)
Status Description
off The server is switched off.
green on The server is switched on and operating normally.
flashing white The BMC firmware is starting up after the server has
been connected to the mains.
white on Server is switched off and connected to the mains
(standby mode).
flashing green & white Server has been switched on but Power Cycle Delay
settings delay it.
iRMC-related status signals
ID indicator Global error
indicator
Description
flashing blue off A remote connection has been
established. Local VGA output has been
disabled during the remote session.
flashing blue flashing orange An emergency flash of the iRMC firmware
is in progress.
For more information about the iRMC flash procedure, see "Basic
software procedures" in the "FUJITSU Server PRIMERGY
TX1320 M5
Upgrade and Maintenance Manual".
HDD prefailure detection
Depending on your hardware configuration HDD prefailure detection will be
supported.
The requirements are:
–
iRMC S6 Firmware
–
supported OOB RAID system
Appendix A
362 Upgrade and Maintenance Manual TX1320 M5
To Next Page
Loading...
Need help?
General