Figure 139: Connecting cables to the backplane (example 8x 2.5-inch HDD/SSD)
▶
Connect the cables to the backplane:
1 SAS cable to backplane connector "X9"
2 If applicable, OOB cable
3 Power cable
4 SAS cable to backplane connector "X10"
For the cable plan, see "Appendix B" on page 519.
Configuration with SAS expander board
▶
For the cabling with a SAS expander board, see "Connecting cables to the
SAS expander board" on page 269.
Hard disk drive (HDD) / solid state disk (SSD)
TX1330 M4 Upgrade and Maintenance Manual 235
To Next Page
Loading...
