Fujitsu PRIMERGY TX1330 M4

Preliminary steps
▶
"Suspending BitLocker functionality" on page 99
.
▶
"Shutting down the server" on page 47.
▶
"Disconnecting the power cord" on page 48.
▶
"Getting access to the component" on page 50.
▶
Remove all HDD/SSD modules, see "Removing 2.5-inch HDD/SSD
modules" on page 216.
Removing the 8x 2.5-inch HDD/SSD front panel
Figure 140: Removing the 8x 2.5-inch HDD/SSD front panel
▶
Remove four screws from the 8x 2.5-inch HDD/SSD front panel.
▶
Pull up the 8x 2.5-inch HDD/SSD front panel to disengage it from the
chassis.
▶
Remove the 8x 2.5-inch HDD/SSD front panel.
Hard disk drive (HDD) / solid state disk (SSD)
TX1330 M4 Upgrade and Maintenance Manual 237