Fujitsu PRIMERGY TX1330 M4

▶
"Getting access to the component" on page 50
.
Removing accessible drive dummy covers
▶
Remove accessible drive filler covers from the required bays, see
"Accessible drive filler covers" on page 92.
▶
Remove accessible drive covers, see "Accessible drive covers" on page 95.
Installing the HDD/SSD or PCIe SSD backplane
▶
If applicable, install the HDD/SSD backplane or the PCIe backplane on the
8x 2.5-inch HDD/SSD extension box, see "Installing the 2.5-inch HDD/SSD
SAS backplane" on page 229.
Installing the 8x 2.5-inch HDD/SSD extension box
CAUTION
▶
If you install an extension box a redundant power supply is
necessary.
Hard disk drive (HDD) / solid state disk (SSD)
242 Upgrade and Maintenance Manual TX1330 M4