Removing the FBU from the FBU holder
Figure 210: Removing the FBU from the FBU holder
▶
Pull the FBU at a slight angle out of the holder.
Concluding steps
▶
If applicable, install the SAS expander board holder
, see "Installing the SAS
expander board holder " on page 271.
▶
"Reassembling" on page 66.
▶
"Connecting the power cord" on page 79.
▶
"Switching on the server" on page 81.
Expansion cards and backup units
TX1330 M4 Upgrade and Maintenance Manual 327
To Next Page
Loading...
