GRAUPNER mc-16 - Page 133

335 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

133

Program description - Dual Rate / Expo | Helicopter models

100%

100%

DUAL

–––

C3

–––

SEL

normal

Roll

Nick

Tail

111%

The vertical dashed line shows the current nick

stick position. Set the Expo values as neces-

sary in the same manner..

Table of Contents

Default Chapter2
- Table of Contents2
General Notices3
- Warning and Note Symbols3
- Safety Notices4
- Safety Notices and Handling Regulations for Lithium-Ion (Liio) and Lithium-Polymer (Lipo) Batteries8
- Environmental Protection Notices10
- Foreword12
- Remote Control Set Description13
- Technical Data17
General Operating Notices18
- Transmitter18
- Battery Operation Timer19
- General Charging Notices19
  - Opening the Transmitter Housing20
- Lithium Battery CR 203220
Transmitter Description Front Side23
- Face-Side Connectors24
- Charger Socket24
- DSC Jack24
- Data Jack25
- Headset Connector25
- Card Slot26
- Mini-USB Connector28
- Bottom Side Transmitter Interior29
- Display and Keypad30
- Operating the "Data Terminal31
- Shortcuts32
- Concealed Menu Columns33
Commissioning the Transmitter48
- Transmitter Firmware Updates50
- Restoring the Transmitter Software51
Receiver Initialization52
- Receiver Firmware Updates53
- Secure Receiver Settings54
Installation Notices54
- Receiver Power Supply56
- Definitions of Terms58
- Physical Control, Switch and Control Switch Assignments60
- Digital Trim62
Winged Models64
- Receiver Layout65
- Servos in Wrong Direction65
Helicopter Models66
- Receiver Layout67
Program Descriptions Charger Socket68
- Loading a New Memory Location68
- Model Select71
- Copy / Erase72
Suppress Codes76
- Suppress Models77
- Base Setup Model78
- Model Type98
- Helicopter Type102
- Servo Adjustment106
  - Stick Mode110
    - Helicopter Model110
    - Winged Model112
- Control Adjust116
  - Helicopter Model116
- Dual Rate / Expo126
  - Winged Model126
  - Helicopter Model130
- Channel 1 Curve137
  - Helicopter Model137
- Switch Display140
- Control Switches141
- Logical Switches144
  - How Is a Flight Phase Programmed146
- Phase Settings152
- Phase Assignment154
- Phase Trim« (Winged Model)156
- Non-Delayed Channels157
- Timers (General)158
- Flight Phase Timers162
  - What Is a Mixer165
- Wing Mixers166
Helicopter Mixer184
- Fine-Tuning the Throttle and Collective Pitch Curve195
- Autorotation Setting198
- General Notes on Freely Programmable Mixers200
Free Mixers201
- Linear Mixers205
- Curve Mixers207
MIX Active / Phase211
MIX-Only Channel212
Dual Mixer214
Swashplate Mixer216
Fail Safe216
Teacher/Pupil221
- Wireless Hott System222
Tx. Output Swap226
Profi Trim228
- Winged Model228
- Helicopter Model230
Trim Memory232
- Winged Model232
- Helicopter Model234
Telemetry236
- Important Notices236
- Settings & Dataview238
  - Satellite Mode247
  - Sensor(S)248
- Sensor (Select)250
- Rf Status View251
- Voice Trigger252
Channel Sequencer254
Multichannel257
Ring Limiter260
- MP3 Player264
- Basic Settings, Transmitter266
- Servo Display274
- Servo Test275
- Code Lock276
- Info Display278
  - Introduction280
Programming Examples280
- Winged Model First Steps282
  - Incorporating an Electric Drive289
- Helicopter Models320
Appendix332
- FCC Information332
- Declaration of Conformity333
- Warranty Certificate334

Other manuals for GRAUPNER mc-16

Operating Instructions49 pages

Related product manuals

Preview: GRAUPNER HoTT MC-16 Series

GRAUPNER HoTT MC-16 Series

Preview: GRAUPNER mc-26

Preview: GRAUPNER MC-32EX

GRAUPNER MC-32EX

Preview: GRAUPNER MC-20 HoTT

GRAUPNER MC-20 HoTT

GRAUPNER HoTT MC-20 Series

Preview: GRAUPNER Kingpad mc-32 Edition

GRAUPNER Kingpad mc-32 Edition

Preview: GRAUPNER MX-16S

GRAUPNER MX-16S

GRAUPNER mz-12 HOTT

Preview: GRAUPNER mx-20 Hott

GRAUPNER mx-20 Hott

Preview: GRAUPNER mx-16 HOTT

GRAUPNER mx-16 HOTT

Preview: GRAUPNER MX-12 - PROGRAMMATION

GRAUPNER MX-12 - PROGRAMMATION