250
Program description - Telemetry
SENSOR
Display of active / inactive sensors
Type transmitter mc-16 HoTT with firmware
version V1.010 or higher, or type transmitter
mc-20 HoTT with firmware V1.030 or later
recognize automatically a sensor connected to the
receiver.
After selection of the desired menu line with the
selection keys of the left or right four-way button …
TELEMETRY
SETTING & DATA VIEW
SENSOR SELECT
RF STATUS VIEW
VOICE TRIGGER
TEL.RCV.
RCV CH1
… and a subsequent tap on the centre SET key of the
right four-way button, the selected sub-menu will open.
SENSOR SELECT
RECEIVER
GENERAL MODULE
VARIO MODULE
ELECTRIC AIR.MOD
GPS
ESC
This menu option can be used to determine which of
the graphic displays described on page 40, as well
as those described previously for sub-menu »SET-
TING & DATAVIEW«, can be selected and which
remain hidden.
Activate (
) or deactivate ( ) the display of respec-
tive sensors by selecting the desired lines with the
selection keys of the left or right four-way button then
tapping on the centre SET key of the right four-way
button, e. g.:
SENSOR SELECT
RECEIVER
GENERAL MODULE
VARIO MODULE
ELECTRIC AIR.MOD
GPS
You must make this selection in order to include the
corresponding sensor in the “SELECT VOICE MES-
SAGE” sub-menu, see page 252, and to display
telemetry data in the respective data displays, starting
on page 40.
SENSOR SELECT
Selecting sensors
Type transmitter mc-16 HoTT with firmware
version V1.010 or higher, or type transmitter
mc-20 HoTT with firmware V1.030 or later
recognize automatically a sensor connected to the re-
ceiver.
TELEMETRY
SETTING & DATA VIEW
SENSOR
RF STATUS VIEW
VOICE TRIGGER
TEL.RCV.
RCV CH1
Activate ( ) or inactive ( ) sensors are automatically
marked in this submenu. A manual selection of sensors
is therefore no longer necessary and also not possible:
SENSOR
RECEIVER
GENERAL MODULE
VARIO MODULE
ELECTRIC AIR.MOD
GPS
ESC
To Next Page
Loading...
Need help?
General
