252
Program description - Telemetry
After selection of the desired menu line with the
selection keys of the left or right four-way button …
TELEMETRY
SETTING & DATA VIEW
SENSOR SELECT
RF STATUS VIEW
VOICE TRIGGER
TEL.RCV.
RCV CH1
… and a subsequent tap on the centre SET key of the
right four-way button will open the selected sub-menu.
Firmware version V1101 and lower
–––
–––
–––
AIR ESC
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
GENERAL MODULE
ELECTRIC AIR.MOD
VARIO MODULE
GPS
Note:
• Independently by the rmware version
the sensors displayed by your transmitter
here vary according to the information
you have entered in the “SELECT SENSOR”
sub-menu; see page 250.
• The screen-shot above shows the maximum
number of options, corresponding to “all sensors
selected”.
Firmware version V1102 and higher
–––
–––
–––
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
AUTO
GPS
REPEAT
–––
–––
–––
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
AUTO
In order to be able to start the voice output through the
headphone connection, at the very least the “REPEAT”
line must be assigned to a switch. The takes place as
described in the section “Physical control, switch and
control switch assignments” on page 60:
–––
–––
–––
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
Move desired switch
to ON position
(ext. switch: SET)
–––
–––
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
7
AUTO
With this switch you can have the last respective voice
trigger repeated for the duration of the time set to the
left of the switch, as long as the assigned switch is
closed.
Simultaneously pressing the Select buttons or
of the right-hand four-way button (CLEAR) resets the
time value to “1 SEC.”.
TRIG
With a switch assigned to this line, preferably a push-
button, switch the selected voice messages in rotation
on to the next voice message for the below-described
“TRANSMITTER”, “RECEIVER” and “SENSOR” op-
tions.
8
7
–––
VOICE TRIGGER
REPEAT 5SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
AUTO
VARIO
Firmware version V1101 and lower
If the “VARIO MODULE” line is activated (
) in the
»SENSOR SELECT« sub-menu, as described on
page 250, a switch assigned to one of these lines
can be used to call up vario-specific voice messages
for the headset connection which are completely inde-
pendent of other voice messages, i. e. voice messages
triggered by altitude changes, such as the message
“slowly ascend/descend”:
8
7
15
VOICE TRIGGER
REPEAT 5SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
VOICE TRIGGER
To Next Page
Loading...
Need help?
General
