GRAUPNER mc-16 - Page 253

253
Program description - Telemetry
Firmware version V1102 and higher
If in the model several Vario sensors are available,
for example because a General Electric and a GPS
module are installed, determining Vario sensor of the
announcement will be selected from firmware version
V1103:
8
7
15
VOICE TRIGGER
REPEAT 5SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
AUTO
The choices are: VARIO, GAM, EAM, GPS and AUTO.
(In the AUTO position the relevant sensor is selected ac-
cording to the order of the mentioned sensors.)
TRANSMITTER
After selection of the desired menu line with the 
selection keys of the left or right four-way button …
8
7
15
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
VARIO AUTO
… and a subsequent tap on the centre SET key of the
right four-way button will open the selected sub-menu.
TX VOLT:
MODELTIME:
BATTERYTIME:
TIMER(GE.)CENTER:
TIMER(GE.)TOP:
PHASE TIMER:
TIME:
Here, after selection of the desired line with the 
selection keys of the left or right four-way button and
a subsequent tap on the centre SET key of the right
four-way button, the selected voice message can be
activated ( ) or deactivated ( ).
TX VOLT:
MODELTIME:
BATTERYTIME:
TIMER(GE.)CENTER:
TIMER(GE.)TOP:
PHASE TIMER:
TIME:
RECEIVER
After selection of the desired menu line with the 
selection keys of the left or right four-way button …
8
7
15
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
VARIO
AUTO
… and a subsequent tap on the centre SET key of the
right four-way button will open the selected sub-menu:
TEMP:
STRENGTH:
RX VOLT:
LOWVOLT:
Here, after selection of the desired line with the 
selection keys of the left or right four-way button and
a subsequent tap on the centre SET key of the right
four-way button, the selected voice message can be
activated ( ) or deactivated ( ).
“Sensors”
These lines only appear, according to the firmware ver-
sion, if you have already activated at least one sensor
in the “SELECT SENSOR” sub-menu of the »Telem-
etry« menu; see page 250. The method of selecting
corresponding voice messages is as described in the
previous sections.
Note:
The points you select here are entirely
independent of the “VARIO” messages.