71
Program description - Model select
Model select
Call up model 1 … 20 (mc-16) or 1 … 24 (mc-20)
This option is available on both transmit-
ter types.
The basic operation of the transmitters
keys was explained on pages 30 and
31 and, on the previous double-page, explanations
were provided for navigating to the multi-function list
and about how to make allocations for a new model
memory. At this point we now wish to begin with the
“normal” description of individual menu items in the se-
quence they are arranged in the transmitter. Therefore
we will begin with the menu …
Model select
Copy / Erase
Suppress menus
Suppress models
Model select
Base setup model
Model type
Copy / Erase
Suppress menus
Suppress models
Model select
Base setup model
Helicopter type
Select the »Model select« menu with the selection
keys of the left or right four-way button then briefl y tap
on the SET key of the right four-way button.
Notes:
• Firmware V109x up to V1100
Attention!
Switch-OFF
the Receiver first!
If this message appears, there is a telemetry link to a
receiving system operational. Turn off this and wait until
the display is briefl y hidden afterward automatically.
• Firmware V1101
If the currently active model “Global” bound, a model
change is only possible after switching off the receiving
system for safety reasons:
Attention!
Switch-OFF
the Receiver first!
If this message appears, there is a telemetry connec-
tion to an operationally ready receiver system. Switch
that receiver system off:
01
03
04
05
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
06
MR12
GR12
MR12
–––
free
free
As many as 20 respectively 24 complete model set-
tings, including digital trim values for the trim buttons,
can be stored. Trimming is stored automatically such
that a switch-over from one model to another does not
cause a loss of current trim settings. To the right of the
model number, each occupied model memory line in
this display shows a pictograph of the model type as
well as the model’s name entered for the model in its
»Basic settings, model« menu, page 78 or 88.
The code, if present, for the receiver “bound” to the
model memory location will appear in right the line.
Now, with the selection keys of the left or right
four-way button, select the desired model memory
from the list and activate it with a tap on the SET key.
A tap on the ESC key will cause a return to the previ-
ous menu page without activating a model change.
Notes:
• If, after a model change, the “Throttle too high”
warning appears, the throttle/pitch stick (C1) or the
throttle limiter – by default, the right-side propor-
tional rotary slider – is too far in the full throttle di-
rection.
Notes:
•
If a model change causes the message …
Thr
too
high!
… appears, then the throttle / collective pitch stick
(Ch1) or the throttle limiter – by default the right-
hand side-mounted proportional rotary slider – is
too far in the direction of full-throttle.
• If a model change causes the message …
BIND. N/A
OK
… to appear then binding settings should be
checked.
• If a model change causes the message …
Fail Safe
setup
t.b.d.
… to appear then respective fail safe settings
should be checked.
• If battery voltage is too low, the model switchover
cannot be made due to reasons of safety. An ap-
propriate message will appear in the screen:
not possible now
voltage too low
mc
16 20
To Next Page
Loading...
Need help?
General
