72
Program description - Copy / Erase
Note:
If the currently active model memory is to be
erased, a model type “Winged” or “Heli” must
be de ned immediately after the erase
process. If, however, an inactive memory location is
erased, it will subsequently appear in “Model select”
list as “free”.
Copy model model
Select the “Copy model model” sub-menu with the
selection keys of the left or right four-way button
then tap the SET key:
Copy flight phase
Erase model
Copy model–>model
=>
=>
=>
Export to SD
Import from SD
=>
=>
=>
=>
SWITCHING RF OFF
OK
If the message shown above should appear, the trans-
mitter’s RF module is still active.
You can interrupt the process by pressing the central
ESC button of the left-hand four-way button.
Pressing the SET button of the right-hand four-way
button resumes the process. However, if the receiving
system is switched on, you should switch it off before
doing this.
Choose the model to be copied with the selection
keys of the left or right four-way button …
01
03
04
05
frei
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
Copy from model:
MR12
MR12
M–––
GR12
Note:
Attention!
Switch-OFF
the Receiver first!
If this message appears, there is an active telemetry
link to a receiving system. Turn off this and wait until
the display is briefl y automatically hidden afterward.
Choose the model to be erased with the selection
keys of the left or right four-way button …
01
03
04
05
frei
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
model to be erased :
MR12
GR12
MR12
M–––
… whereby another tap on the SET key will cause the
confi rmation request …
Model really
GRAUBELE
to be erased?
NO
YES
01
… to appear. A NO response will cause the process
to be canceled and a return to the previous screen.
Selecting the YES response with the selection key of
the left or right four-way button followed by confi rma-
tion of the selection with a brief tap on the SET key will
erase the selected model memory.
Caution:
This erase process cannot be undone. All
data in the selected model memory will be
erased completely.
Copy / Erase
Erase model, copy model model, copy from or to SD card, copy fl ight phases
This option is available on both transmit-
ter types.
Use the selection keys on the left or
right four-way button to select the »Copy /
Erase« option in the multi-function menu:
Suppress menus
Suppress models
Model select
Base setup model
Model type
Copy / Erase
Suppress menus
Suppress models
Model select
Base setup model
Helicopter type
Copy / Erase
Open this menu option with a tap on the centre SET
key of the four-way button pad:
Erase model
Copy flight phase
Erase model
Copy model–>model
=>
=>
=>
Export to SD
Import from SD
=>
=>
=>
=>
Select the “Erase model” sub-menu with the
selection keys of the left or right four-way button then
briefl y tap on the SET key.
mc
16 20
To Next Page
Loading...
Need help?
General
