73
Program description - Copy / Erase
… then, following the change into the “Copy to model”
window caused by another tap on the SET key of the
right four-way button, the destination memory can be
selected with the selection keys of the left or right
four-way button. Yet another tap on the SET key will
then confi rm the copy process or a tap on ESC key
will cause the copy to be cancelled. A memory location
which is already occupied can be overwritten.
01
03
04
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
Copy to model:
05
free
MR12
GR12
MR12
M–––
After confi rming the selected model memory with a tap
on the SET key, a confi rmation request will appear:
Modell really
ULTIMATE
to be copied?
NO
YES
01
03
free
A NO response will cancel the process and return
the screen to the originating screen. If the YES
response is selected and confi rmed with a tap on the
SET key then the selected source model will be copied
into the selected model memory destination.
Note:
•
If a memory speci cally bound model
copied to any other model memory from
the same transmitter, the receiver in the
destination memory is to rebind.
• When a station is speci cally bound model cop-
ied to any other model memory from the same
transmitter, the receiver existing bond is retained.
Exporting to SD card
Use the selection keys of the left or right four-way
button to select the “Export to SD” sub-menu.
=>
=>
=>
=>
=>
=>
=>
Copy flight phase
Erase model
Copy model–>model
Export to SD
Import from SD
... and tap on the SET key,
Note:
Attention!
Switch-OFF
the Receiver first!
If this message appears, there is an active telemetry
link to a receiving system. Turn off this and wait until
the display is briefl y automatically hidden afterward.
Choose the model to be exported with the selec-
tion keys of the left or right four-way button …
01
03
04
05
frei
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
export to SD-CARD:
MR12
GR12
MR12
M–––
After confi rming the selected model memory with a tap
on the SET key, a confi rmation request will appear:
modell
ULTIMATE
export ?
NO
YES
01
SD-CARD
A NO response will cancel the process and return the
screen to the originating screen. If the YES response
is selected then confi rmed with a tap on the SET key,
the selected model will be copied to the SD card.
Notes:
• Should the notice …
SD-CARD
INSERT
OK
… appears instead of a screen for model
selection, there is no SD card in the trans-
mitter’s card slot, see page 26.
• In addition to model data, binding data is also cop-
ied by this process. This means that a receiver
system which was/is bound to the original model
memory can also be operated in the SAME trans-
mitter by its copy without establishing the bond
again.
• An exported xed-wing model will be stored on
the memory card in the \\Models\mc-16 respec-
tively \\Models\mc-20 folder with a lename for-
mat of “aModelname.mdl” and a helicopter model
with a lename format of “hModelname.mdl”. On
the other hand, if a “nameless” model is export-
ed, its data will be stored on the memory card un-
der “aNo Name.mdl” or “hNoName.mdl”, as appro-
priate.
• Some special characters that can be used in mod-
el names are subject to speci c restrictions asso-
ciated with the FAT or FAT32 le system used by
the memory cards and these special characters
To Next Page
Loading...
