74
Program description - Copy / Erase
Note:
The export date posted at the right end of
each model name line is represented in the
format “year/month/day”.
After another tap on the SET key of the right four-way
button, the “import from SD-CARD” window will ap-
pear. Now the destination memory location can be
selected with the selection keys of the left or right
four-way button then confi rmed with a tap on the SET
key, or the process can be canceled with a tap on the
ESC key. A memory location which is already occupied
can be overwritten.
01
03
04
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
import to model:
05
free
MR12
GR12
MR12
M–––
After confi rming the selected model memory with a tap
on the SET key, a confi rmation request will appear:
modell
ULTIMATE
import ?
NO
YES
03
free
A NO response will cancel the process and return the
screen to the originating screen. If the YES response
is selected and confi rmed with a tap on the SET key
then the selected source model will be imported into
the selected destination model memory.
Notes:
• If the message …
SD-CARD
INSERT
OK
will be replaced during the copy process with a til-
de (~).
• A model le already on the memory having the
same name as the le to be copied will be over-
written without warning.
Importing from SD card
Use the selection keys of the left or right four-way
button to select the “Import from SD” sub-menu then
tap on the SET key.
Copy flight phase
Erase model
Copy model–>model
=>
=>
=>
Export zu SD
Import von SD
=>
=>
=>
=>
SWITCHING RF OFF
OK
If the message shown above should appear, the trans-
mitter’s RF module is still active.
You can interrupt the process by pressing the central
ESC button of the left-hand four-way button.
Pressing the SET button of the right-hand four-way
button resumes the process. However, if the receiving
system is switched on, you should switch it off before
doing this.
Select the model to be imported from the SD memory
card with the selection keys of the left or right four-
way button:
05
frei
EXTRA
ALPINA
COBRA
BELL47G
import from SD-CARD:
11/03/10
11/03/11
11/03/11
11/03/12
… appears instead of a screen for model
selection, there is no SD card in the trans-
mitter’s card slot, see page 26.
• If a memory speci cally bound and in the mean-
time on the SD card, for example, for backup pur-
poses, the same model is loaded back into the
original model memory from the same transmitter,
the receiver existing binding is retained.
On the other hand, the same model is copied to a
different model memory, or even in another chan-
nel, the affected receiver MUST be re-bound.
• In addition to model data, binding data is also im-
ported by this process. This means that a receiver
system which was/is bound to the original model
memory can also be operated in the SAME trans-
mitter by its copy without establishing the bond
again.
• In principle the model memories of the mx-20 and
mc-20 transmitters are compatible, BUT:
If you wish to carry out an “Import from SD card” in
the other transmitter you must rst copy or move
the model memory concerned to the appropriate
folder on a PC. For example: from \\Models\mc-20
to \\Models\mx-20, or vice versa.
C A U T I O N :
After you have carried out an “Import from
SD card” it is absolutely essential to check
all the model functions with great care.
Note also that the transmitter control and switch
functions may need to be adjusted to suit the new
transmitter.
To Next Page
Loading...
Need help?
General
