35
Transmitter description - Warning notices
Warning notices
Batt. must
be re-
charged!!
Transmitter operating
voltage is too low
BIND. N/A
OK
“Bind not available“
A receiver has not yet
been bound to the
currently active model
memory. A brief tap on
the SET key will cause
a direct jump to the ap-
propriate option.
Attention!
Switch-OFF
the Receiver first!
This warning appears
if you try to change
models in the »Model
select« menu with the
receiver of the previ-
ously active model still
switched on.
CAN‘T
RECEIVE
DATA
OK
No bound receiver in
range
Please select
RF on/off?
ON OFF
Only for a receiver
that has already been
bound:
Please select RF “on“ or
“off“? RF
RF
must be
OFF
OK
Request to switch off
the RF section.
Warning notices
Fail Safe
setup
t.b.d.
Failsafe has not yet
been activated
Thr
too
high!
The throttle stick of a
fi xed-wing model, or
stick and/or throttle
limiter of a helicopter, is
too far in the direction of
full-throttle.
No
pupil
signal
Connection between
teacher and pupil trans-
mitter is interrupted
SD-CARD
INSERT
OK
No SD or SDHC mem-
ory card in the card slot
or card is not legible
• Within the line “Power on” the menu “general. Set-
tings “(page 270) set time the transmitter has not
been operated. The display shows ...
Power on warning
is active!
• ..., The “WARNING” LED to the right of the ON /
OFF switch will blink and acoustic signals will sound.
If the transmitter is now still not actuated switches
• If battery voltage is too low, a model switch is blocked
for reasons of safety. An appropriate message will
appear in the screen:
not possible now
voltage too low
• Is the “wireless teacher/pupil connection” that was
active when the transmitter was last used to be
continued, ACT or switched off INH?
Please select
Trainer link?
ACT INH
Please select
Trainer link?
ACT INH
To Next Page
Loading...
Need help?
General
