EasyManuals Logo

H3C S5120-EI Series User Manual

H3C S5120-EI Series
1166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1042 background imageLoading...
Page #1042 background image
1-3
Basic Concepts of NQA
Test group
Before performing an NQA test, you need to create an NQA test group, and configure NQA test
parameters such as test type, destination address and destination port.
Each test group has an administrator name and operation tag, which can uniquely define a test group.
Test and probe
After an NQA test is started, one test is performed at a regular interval and you can set the interval as
needed.
One NQA test involves multiple consecutive probes and you can set the number of the probes.
Only one probe can be made in one voice test.
In different test types, probe has different meanings:
z For a TCP or DLSw test, one probe means one connection;
z For a UDP jitter or a voice test, multiple packets are sent successively in one probe, and the
number of packets sent in one probe depends on the configuration of the probe packet-number
command;
z For an FTP, HTTP or DHCP test, one probe means to carry out a corresponding function;
z For an ICMP echo or UDP echo test, one packet is sent in one probe;
z For an SNMP test, three packets are sent in one probe.
NQA client and server
NQA client is the device initiating an NQA test and the NQA test group is created on the NQA client.
NQA server processes the test packets sent from the NQA client, as shown in
Figure 1-2. The NQA
server makes a response to the request originated by the NQA client by listening to the specified
destination address and port number.
Figure 1-2 Relationship between the NQA client and NQA server
In most NQA tests, you only need to configure the NQA client; while in TCP, UDP echo, UDP jitter, and
voice tests, you must configure the NQA server.
You can create multiple TCP or UDP listening services on the NQA server, with each listening service
corresponding to a specified destination address and port number. The IP address and port number
specified for a listening service on the server must be consistent with those on the client and must be
different from those of an existing listening service.

Table of Contents

Other manuals for H3C S5120-EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S5120-EI Series and is the answer not in the manual?

H3C S5120-EI Series Specifications

General IconGeneral
BrandH3C
ModelS5120-EI Series
CategorySwitch
LanguageEnglish

Related product manuals