1-2
z Configuring the Device Name
z Configuring the System Clock
z Enabling/Disabling the Display of Copyright Information
z Configuring a Banner
z Configuring CLI Hotkeys
z Configuring User Privilege Levels and Command Levels
z Displaying and Maintaining Basic Configurations
Entering/Exiting System View
Follow these steps to enter/exit system view:
To do… Use the command… Remarks
Enter system view from user view
system-view
—
Return to user view from system view
quit
—
With the quit command, you can return to the previous view. You can execute the return command or
press the hot key Ctrl+Z to return to user view.
Configuring the Device Name
The device name is used to identify a device in a network. Inside the system, the device name
corresponds to the prompt of the CLI. For example, if the device name is Sysname, the prompt of user
view is <Sysname>.
Follow these steps to configure the device name:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the device name
sysname sysname
Optional
The device name is “H3C” by default.
Configuring the System Clock
Configuring the system clock
The system clock, displayed by system time stamp, is decided by the configured relative time, time
zone, and daylight saving time. You can view the system clock by using the display clock command.
Follow these steps to configure the system clock:
To do… Use the command… Remarks
Set time and date
clock datetime time date
Optional
Available in user view.
To Next Page
Loading...
