To Next Page

To Previous Page

2-13

The startup file used for the next startup must be saved under the root directory of the storage medium.

You can copy or move a file to the root directory of the storage medium. For the details of the

boot-loader command, refer to Device Management Commands in the System Volume.

Stacking System Upgrade

Network requirements

z As shown in Figure 2-5, use Device as an FTP server, and the PC as the FTP client. An available

route exists between Device and PC.

z PC keeps the updated startup file of the device. Use FTP to upgrade the device and back up the

configuration file.

z Set the username to ftp and the password to pwd for the FTP client to log in to the FTP server.

Figure 2-5 Smooth upgrading using the FTP server

Configuration procedure

1) Configure Device (FTP Server)

# Create an FTP user account ftp, set its password to pwd and the user privilege level to level 3 (the

manage level).

<Sysname> system-view

[Sysname] local-user ftp

[Sysname-luser-ftp] password simple pwd

[Sysname-luser-ftp] authorization-attribute work-directory level 3

# Authorize ftp’s access to the root directory of the flash on the master.

[Sysname-luser-ftp] authorization-attribute work-directory flash:/

# To access the root directory of storage medium of a slave (with the member ID 2):

[Sysname-luser-ftp] authorization-attribute work-directory slot2#flash:/

# Specify ftp to use FTP.

[Sysname-luser-ftp] service-type ftp

[Sysname-luser-ftp] quit

# Enable FTP server.

[Sysname] ftp server enable

H3C S5120-EI Series User Manual

Other manuals for H3C S5120-EI Series