H3C S5120-EI Series User Manual

1-5
Task Remarks
Configuring Optional Parameters Common to an NQA Test Group Optional
Scheduling an NQA Test Group Required
Configuring the NQA Server
Before performing TCP, UDP echo, UDP jitter or voice tests, you need to configure the NQA server on
the peer device. The NQA server makes a response to the request originated by the NQA client by
listening to the specified destination address and port number.
Follow these steps to configure the NQA server:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the NQA server
nqa server enable
Required
Disabled by default.
Configure the UDP or TCP
listening function on the NQA
server
nqa server { tcp-connect |
udp-echo } ip-address
port-number
Required
The IP address and port
number must be consistent with
those configured on the NQA
client and must be different
from those of an existing
listening service.
Enabling the NQA Client
Configurations on the NQA client take effect only when the NQA client is enabled.
Follow these steps to enable the NQA client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the NQA client
nqa agent enable
Optional
Enabled by default.
Creating an NQA Test Group
One test corresponds to one test group. You can configure test types after you create a test group and
enter the test group view.
Follow theses steps to create an NQA test group:
To do… Use the command… Remarks
Enter system view
system-view
—
Create an NQA test group and
enter the NQA test group view
nqa entry admin-name
operation-tag
Required

H3C S5120-EI Series Specifications

General

Brand	H3C
Model	S5120-EI Series
Category	Switch
Language	English