1-8
z Enabling LinkUp/LinkDown Trap Generation for an Aggregate Interface
z Shutting Down an Aggregate Interface
Configuring the Description of an Aggregate Interface
Follow these steps to configure the description of an aggregate interface:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter Layer 2 aggregate
interface view
interface bridge-aggregation
interface-number
—
Configure the description of
the aggregate interface
description text
Optional
By default, the description of an
interface is interface-name
Interface, such as
Bridge-Aggregation1 Interface.
Enabling LinkUp/LinkDown Trap Generation for an Aggregate Interface
To enable an aggregate interface to generate linkUp/linkDown trap messages when the state of the
interface changes, you should enable linkUp/linkDown trap generation on the aggregate interface.
Follow these steps to enable linkUp/linkDown trap generation for an aggregate interface:
To do... Use the command... Remarks
Enter system view
system-view
—
Enable the trap function
globally
snmp-agent trap enable
[ standard [ linkdown | linkup ]
* ]
Optional
By default, linkUp/linkDown
trap generation is enabled
globally and on all interfaces.
Enter aggregate interface
view
interface bridge-aggregation
interface-number
—
Enable linkUp/linkDown trap
generation for the aggregate
interface
enable snmp trap updown
Optional
Enabled by default
Shutting Down an Aggregate Interface
Shutting down or bringing up an aggregate interface affects the selected state of the ports in the
corresponding aggregation group. When an aggregate interface is shut down, all selected ports in its
aggregation group become unselected; when the aggregate interface is brought up, the selected state
of the ports in the corresponding aggregation group is re-calculated.
Follow these steps to shut down an aggregate interface:
To do... Use the command... Remarks
Enter system view
system-view
—
To Next Page
Loading...
Need help?
General