1-4
z To configure this feature for an existing static route, simply associate the static route with a track
entry. For a non-existent static route, configure it and associate it with a Track entry.
z If a static route needs route recursion, the associated track entry must monitor the nexthop of the
recursive route instead of that of the static route; otherwise, a valid route may be mistakenly
considered invalid.
Displaying and Maintaining Static Routes
To do… Use the command… Remarks
Display the current
configuration information
display current-configuration
Display the brief information of
the IP routing table
display ip routing-table
Display the detailed
information of the IP routing
table
display ip routing-table verbose
View information of static
routes
display ip routing-table protocol static
[ inactive | verbose ]
Available in any
view
Delete all the static routes
delete static-routes all
Available In
system view
Static Route Configuration Example
Basic Static Route Configuration Example
Network requirements
The IP addresses and masks of the switches and hosts are shown in the following figure. Static routes
are required for interconnection between any two hosts.
Figure 1-1 Network diagram for static route configuration
To Next Page
Loading...
Need help?
General