H3C S5120-EI Series User Manual

8-3
Controlling Telnet Users by Source MAC Addresses
This configuration needs to be implemented by Layer 2 ACL; a Layer 2 ACL ranges from 4000 to 4999.
For the definition of ACL, refer to ACL Configuration in the Security Volume.
Follow these steps to control Telnet users by source MAC addresses:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a basic ACL or enter
basic ACL view
acl number acl-number
[ match-order { config |
auto } ]
As for the acl number
command, the config keyword
is specified by default.
Define rules for the ACL
rule [ rule-id ] { permit | deny }
rule-string
Required
You can define rules as needed
to filter by specific source MAC
addresses.
Quit to system view
quit
—
Enter user interface view
user-interface [ type ]
first-number [ last-number ]
—
Apply the ACL to control Telnet
users by source MAC
addresses
acl acl-number inbound
Required
The inbound keyword
specifies to filter the users
trying to Telnet to the current
switch.
Layer 2 ACL is invalid for this function if the source IP address of the Telnet client and the interface IP
address of the Telnet server are not in the same subnet.
Configuration Example
Network requirements
Only the Telnet users sourced from the IP address of 10.110.100.52 and 10.110.100.46 are permitted to
log in to the switch.
Figure 8-1 Network diagram for controlling Telnet users using ACLs
Switch
10.110.100.46
Host A
IP network
Host B
10.110.100.52

H3C S5120-EI Series Specifications

General

Brand	H3C
Model	S5120-EI Series
Category	Switch
Language	English