H3C S5120-EI Series User Manual

2-5
To do… Use the command… Remarks
Correlate the DHCP server
group with the current interface
dhcp relay server-select
group-id
Required
By default, no interface is
correlated with any DHCP
server group.
z You can specify up to twenty DHCP server groups on the relay agent and eight DHCP server
addresses for each DHCP server group.
z The IP addresses of DHCP servers and those of relay agent’s interfaces cannot be on the same
subnet. Otherwise, the client cannot obtain an IP address.
z A DHCP server group can correlate with one or multiple DHCP relay agent interfaces, while a relay
agent interface can only correlate with one DHCP server group. Using the dhcp relay
server-select command repeatedly overwrites the previous configuration. However, if the
specified DHCP server group does not exist, the interface still uses the previous correlation.
z The group-id argument in the dhcp relay server-select command was specified by the dhcp
relay server-group command.
Configuring the DHCP Relay Agent Security Functions
Creating static bindings and enable IP address check
The DHCP relay agent can dynamically record clients’ IP-to-MAC bindings after clients get IP
addresses. It also supports static bindings, which means you can manually configure IP-to-MAC
bindings on the DHCP relay agent, so that users can access external network using fixed IP addresses.
For avoidance of invalid IP address configuration, you can configure the DHCP relay agent to check
whether a requesting client’s IP and MAC addresses match a binding (both dynamic and static bindings)
on the DHCP relay agent. If not, the client cannot access outside networks via the DHCP relay agent.
Follow these steps to create a static binding and enable IP address check:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a static binding
dhcp relay security static ip-address
mac-address [ interface interface-type
interface-number ]
Optional
No static binding is created
by default.
Enter interface view
interface interface-type
interface-number
—
Enable invalid IP
address check
dhcp relay address-check { disable |
enable }
Required
Disabled by default.

H3C S5120-EI Series Specifications

General

Brand	H3C
Model	S5120-EI Series
Category	Switch
Language	English