H3C S5120-EI Series - Displaying and Maintaining the TFTP Client

3-3
Follow these steps to configure the TFTP client:
To do… Use the command… Remarks
Enter system view
system-view
—
Control the access to the TFTP
servers from the device through
ACL
tftp-server [ ipv6 ] acl
acl-number
Optional
By default, the access to the
TFTP servers from the device
is not controlled.
Configure the source address
of the TFTP client
tftp client source { interface
interface-type interface-number
| ip source-ip-address }
Optional
A device uses the source
address determined by the
matched route to communicate
with the TFTP server by
default.
Return to user view
quit
—
Download or upload a file in an
IPv4 network
tftp server-address { get | put |
sget } source-filename
[ destination-filename ]
[ source { interface
interface-type interface-number
| ip source-ip-address } ]
Optional
Available in user view
Download or upload a file in an
IPv6 network
tftp ipv6 tftp-ipv6-server [ -i
interface-type
interface-number ] { get | put }
source-file [ destination-file ]
Optional
Available in user view
z If no primary IP address is configured on the source interface, no TFTP connection can be
established.
z If you use the ftp client source command to first configure the source interface and then the
source IP address of the packets of the TFTP client, the new source IP address will overwrite the
current one, and vice versa.
Displaying and Maintaining the TFTP Client
To do… Use the command… Remarks
Display the configuration of the
TFTP client
display tftp client
configuration
Available in any view