1-1
1 IP Routing Overview
Go to these sections for information you are interested in:
z IP Routing and Routing Table
z Routing Protocol Overview
z Displaying and Maintaining a Routing Table
The term “router” in this document refers to a router in a generic sense or a Layer 3 switch.
IP Routing and Routing Table
Routing
Routing in the Internet is achieved through routers. Upon receiving a packet, a router finds an optimal
route based on the destination address and forwards the packet to the next router in the path until the
packet reaches the last router, which forwards the packet to the intended destination host.
Routing Table
Routing table
Routing tables play a key role in routing. Each router maintains a routing table, and each entry in the
table specifies which physical interface a packet destined for a certain destination should go out to
reach the next hop (the next router) or the directly connected destination.
Routes in a routing table can be divided into three categories by origin:
z Direct routes: Routes discovered by data link protocols, also known as interface routes.
z Static routes: Routes that are manually configured.
z Dynamic routes: Routes that are discovered dynamically by routing protocols.
Dynamic routing protocol is not supported on the S5120-EI Series Ethernet Switches.
Contents of a routing table
A routing table includes the following key items:
z Destination address: Destination IP address or destination network.
To Next Page
Loading...
Need help?
General