H3C S5120-EI Series - Configuring the Member Devices; Configuring Access between the Management Device and Its Member Devices

1-13
Removing a member device
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Remove a member device from
the cluster
delete-member member-number
[ to-black-list ]
Required
Rebooting a member device
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Reboot a specified member
device
reboot member { member-number |
mac-address mac-address } [ eraseflash ]
Required
Configuring the Member Devices
Enabling NDP
Refer to Enabling NDP Globally and for Specific Ports.
Enabling NTDP
Refer to Enabling NTDP Globally and for Specific Ports.
Manually Collecting Topology Information
Refer to Manually Collecting Topology Information.
Enabling the Cluster Function
Refer to Enabling the Cluster Function.
Deleting a Member Device from a Cluster
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Delete a member device from the cluster
undo administrator-address
Required
Configuring Access Between the Management Device and Its
Member Devices
After having successfully configured NDP, NTDP and cluster, you can configure, manage and monitor