1-12
0180-C200-000A, cluster management packets cannot traverse these devices. For a cluster to work
normally in this case, you can modify the destination MAC address of a cluster management protocol
packet without changing the current networking.
The management device periodically sends MAC address negotiation broadcast packets to advertise
the destination MAC address of the cluster management protocol packets.
Follow these steps to configure the destination MAC address of the cluster management protocol
packets:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Configure the destination MAC
address for cluster
management protocol packets
cluster-mac mac-address
Required
The destination MAC address
is 0180-C200-000A by default.
Configure the interval to send
MAC address negotiation
broadcast packets
cluster-mac syn-interval
interval-time
Optional
One minute by default.
When you configure the destination MAC address for cluster management protocol packets:
z If the interval for sending MAC address negotiation broadcast packets is 0, the system
automatically sets it to 1 minute.
z If the interval for sending MAC address negotiation broadcast packets is not 0, the interval remains
unchanged.
Cluster Member Management
You can manually add a candidate device to a cluster, or remove a member device from a cluster.
If a member device needs to be rebooted for software upgrade or configuration update, you can
remotely reboot it through the management device.
Adding a member device
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Add a candidate device to the
cluster
add-member [ member-number ]
mac-address mac-address [ password
password ]
Required
To Next Page
Loading...
Need help?
General