H3C S5120-EI Series - Setting LLDP Operating Mode

1-5
To do… Use the command… Remarks
Enter system view
system-view
—
Enable LLDP globally
lldp enable
Required
By default, LLDP is enabled globally.
Enter Ethernet
interface view
interface interface-type
interface-number
Enter
Ethernet
interface
view/port
group view
Enter port
group view
port-group manual
port-group-name
Either of the two is required.
Configuration performed in Ethernet
interface view applies to the current
port only; configuration performed in
port group view applies to all the
ports in the corresponding port
group.
Enable LLDP
lldp enable
Optional
By default, LLDP is enabled on a
port.
To make LLDP take effect, you need to enable it both globally and on the related ports.
Setting LLDP Operating Mode
Follow these steps to set LLDP operating mode:
To do… Use the command… Remarks
Enter system view
system-view
—
Set the initialization delay
period
lldp timer reinit-delay value
Optional
2 seconds by default.
Enter Ethernet
interface view
interface interface-type
interface-number
Enter
Ethernet
interface
view/port
group view
Enter port
group view
port-group manual
port-group-name
Either of the two is required.
Configuration performed in
Ethernet interface view applies
to the current port only;
configuration performed in port
group view applies to all the
ports in the corresponding port
group.
Set the LLDP operating mode
lldp admin-status { disable |
rx | tx | txrx }
Optional
TxRx by default.