H3C S5120-EI Series - Associating the HTTP Service with an ACL; Configuring the Port Number of the HTTP Service; Displaying and Maintaining HTTP

1-2
Follow these steps to enable the HTTP service:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the HTTP service
ip http enable
Required
Configuring the Port Number of the HTTP Service
Configuration of the port number of the HTTP service can reduce the attacks from illegal users on the
HTTP service.
Follow these steps to configure the port number of the HTTP service:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the port number of
the HTTP service
ip http port port-number
Required
By default, the port number of
the HTTP service is 80.
If you execute the ip http port command for multiple times, the last configured port number is used.
Associating the HTTP Service with an ACL
By associating the HTTP service with an ACL, only the clients that pass ACL filtering are allowed to
access the device.
Follow these steps to associate the HTTP service with an ACL:
To do… Use the command… Remarks
Enters system view
system-view
—
Associate the HTTP service
with an ACL
ip http acl acl-number
Required
The HTTP service is not
associated with an ACL by
default.
Displaying and Maintaining HTTP
To do… Use the command… Remarks
Display information about
HTTP
display ip http
Available in any view