H3C S5120-EI Series User Manual

5-1
5 Logging in Through Web-based Network
Management System
Introduction
An S5120-EI series switch has a built-in Web server. You can log in to an S5120-EI series switch
through a Web browser and manage and maintain the switch intuitively by interacting with the built-in
Web server.
To log in to an S5120-EI series switch through the built-in Web-based network management system,
you need to perform the related configuration on both the switch and the PC operating as the network
management terminal.
Table 5-1 Requirements for logging in to a switch through the Web-based network management
system
Item Requirement
Start the Web server
The IP address of the management VLAN of the switch is configured.
The route between the switch and the network management terminal
is available. (Refer to the module “IP Addressing and Performance”
and “IP Routing” for more.)
Switch
The user name and password for logging in to the Web-based
network management system are configured.
IE is available.
PC operating as the
network management
terminal
The IP address of the management VLAN interface of the switch is
available.
Web Server Configuration
Logging in Through Web-based Network Management configuration
To do… Use the command… Remarks
Enter system view
system-view
-
Add a local user and enter local
user view
local-user user-name
Required
No local user exists by default.
Configure a password for the
local user
password { cipher | simple }
password
Required
No password exists by default.
Configure the authorization
attributes for the local user
authorization-attribute level
level
Optional
By default, no authorization
attribute is configured for a
local user.

H3C S5120-EI Series Specifications

General

Brand	H3C
Model	S5120-EI Series
Category	Switch
Language	English