H3C S5120-EI Series User Manual

1-6
z This function is available for auto-negotiation-capable Gigabit Layer-2 Ethernet electrical ports
only..
z If you repeatedly use the speed and the speed auto commands to configure the transmission rate
on a port, only the latest configuration takes effect.
Configuring Storm Suppression
You can use the following commands to suppress the broadcast, multicast, and unknown unicast traffic.
In interface configuration mode, the suppression ratio indicates the maximum broadcast, multicast or
unknown unicast traffic that is allowed to pass through an interface. When the broadcast, multicast, or
unknown unicast traffic over the interface exceeds the threshold, the system will discard the extra
packets so that the broadcast, multicast or unknown unicast traffic ratio can drop below the limit to
ensure that the network functions properly.
The storm suppression ratio settings configured for an Ethernet interface may get invalid if you enable
the storm constrain for the interface. For information about the storm constrain function, see
Configuring the Storm Constrain Function on an Ethernet Interface.
Follow these steps to set storm suppression ratios for one or multiple Ethernet interfaces:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter
Ethernet
interface
view
interface interface-type
interface-number
Enter
Ethernet
interface
view or port
group view
Enter port
group view
port-group manual
port-group-name
Use either command.
If configured in Ethernet interface view,
this feature takes effect on the current
port only; if configured in port group
view, this feature takes effect on all
ports in the port group.
Set the broadcast storm
suppression ratio
broadcast-suppression
{ ratio | pps max-pps }
Optional
By default, all broadcast traffic is
allowed to pass through an interface,
that is, broadcast traffic is not
suppressed.
Set the multicast storm
suppression ratio
multicast-suppression
{ ratio | pps max-pps }
Optional
By default, all multicast traffic is
allowed to pass through an interface,
that is, multicast traffic is not
suppressed.

H3C S5120-EI Series Specifications

General

Brand	H3C
Model	S5120-EI Series
Category	Switch
Language	English