2-3
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the MAC
Information queue length
mac-address information
queue-length value
Optional
50 by default
Setting the MAC Information queue length to 0 indicates that the device sends a Syslog or Trap
message to the network management device as soon as a new MAC address is learned or an existing
MAC address is deleted.
MAC Information Configuration Example
MAC Information Configuration Example
Network requirements
z Host A is connected to a remote server (Server) through Device.
z Enable MAC Information on GigabitEthernet 1/0/1 on Device. Device sends MAC address change
information using Syslog messages to Host B through GigabitEthernet 1/0/3. Host B analyzes and
displays the Syslog messages.
Figure 2-1 Network diagram for MAC Information configuration
Configuration procedure
1) Configure Device to send Syslog messages to Host B.
Refer to Information Center Configuration in the System Volume for details.
2) Enable MAC Information.
# Enable MAC Information on Device.
<Device> system-view
[Device] mac-address information enable
# Configure MAC Information mode as Syslog.
To Next Page
Loading...
Need help?
General