H3C S5120-EI Series User Manual

1-30
To do… Use the command… Remarks
Clear buffered stop-accounting
requests that get no responses
reset stop-accounting-buffer
{ radius-scheme radius-server-name |
session-id session-id | time-range
start-time stop-time | user-name
user-name } [ slot slot-number ]
Available in user
view
Configuring HWTACACS
Different from RADIUS, except for deleting HWTACACS schemes and changing the IP addresses of
the HWTACACS servers, you can make any changes to HWTACACS parameters, whether there are
users online or not.
Creating a HWTACACS scheme
The HWTACACS protocol is configured on a per scheme basis. Before performing other HWTACACS
configurations, follow these steps to create a HWTACACS scheme and enter HWTACACS scheme
view:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a HWTACACS scheme and
enter HWTACACS scheme view
hwtacacs scheme
hwtacacs-scheme-name
Required
Not defined by default
z Up to 16 HWTACACS schemes can be configured.
z A scheme can be deleted only when it is not referenced.
Specifying the HWTACACS Authentication Servers
Follow these steps to specify the HWTACACS authentication servers:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a HWTACACS scheme
and enter HWTACACS scheme
view
hwtacacs scheme
hwtacacs-scheme-name
Required
Not defined by default

H3C S5120-EI Series Specifications

General

Brand	H3C
Model	S5120-EI Series
Category	Switch
Language	English