H3C S5120-EI Series User Manual

1-8
To do… Use the command… Remarks
Configure common optional
parameters
See
Configuring Optional
Parameters Common to an
NQA Test Group
Optional
z As DHCP test is a process to simulate address allocation in DHCP, the IP address of the interface
performing the DHCP test will not be changed.
z After the DHCP test is completed, the NQA client will send a DHCP-RELEASE packet to release
the obtained IP address.
Configuring an FTP Test
An FTP test is mainly used to test the connection between the NQA client and a specified FTP server
and the time necessary for the FTP client to transfer a file to or download a file from the FTP server.
Configuration prerequisites
Before an FTP test, you need to perform some configurations on the FTP server. For example, you
need to configure the username and password used to log onto the FTP server. For the FTP server
configuration, see File System Management Configuration in the System Volume.
Configuring an FTP test
Follow these steps to configure an FTP test:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as FTP
and enter test type view
type ftp
Required
Configure the destination
address for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for a test
operation is the IP address of the
FTP server.
Configure the source IP
address of a probe request
source ip ip-address
Required
By default, no source IP address is
specified.
The source IP address must be that
of an interface on the device and the
interface must be up. Otherwise, the
test will fail.

H3C S5120-EI Series Specifications

General

Brand	H3C
Model	S5120-EI Series
Category	Switch
Language	English