Access Volume Organization
Manual Version
6W100-20090630
Product Version
Release 2202
Organization
The Access Volume is organized as follows:
Features Description
Ethernet Port
This document describes:
z Combo Port Configuration
z Basic Ethernet Interface Configuration
z Configuring Flow Control on an Ethernet Interface
z Configuring the Suppression Time of Physical-Link-State Change on
an Ethernet Interface
z Configuring Loopback Testing on an Ethernet Interface
z Configuring a Port Group
z Configuring an Auto-negotiation Transmission Rate
z Configuring Storm Suppression
z Setting the Interval for Collecting Ethernet Interface Statistics
z Enabling Forwarding of Jumbo Frames
z Enabling Loopback Detection on an Ethernet Interface
z Configuring the MDI Mode for an Ethernet Interface
z Testing the Cable on an Ethernet Interface
z Configuring the Storm Constrain Function on an Ethernet Interface
Link aggregation
Link aggregation aggregates multiple physical Ethernet ports into one
logical link. This document describes:
z Basic Concepts of Link Aggregation
z Configuring a Static Aggregation Group
z Configuring a Dynamic Aggregation Group
z Configuring an Aggregate Interface
z Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Port Isolation
The port isolation feature allows you to isolate different ports within the
same VLAN. This document describes:
z Introduction to Port Isolation
z Configuring the Isolation Group
To Next Page
Loading...
