H3C S5120-EI Series - Page 548

2-3
Form Description
dscp dscp-list
Specifies to match packets by DSCP precedence. The dscp-list
argument is a list of DSCP values in the range of 0 to 63.
Even though you can provide up to eight space-separated DSCP
values for this argument, the S5120-EI switch supports only one
DSCP value in a rule. If you configure multiple DSCP values in a
rule, the rule cannot be issued.
ip-precedence
ip-precedence-list
Specifies to match packets by IP precedence. The
ip-precedence-list argument is a list of IP precedence values in the
range of 0 to 7.
Even though you can provide up to eight space-separated IP
precedence values for this argument, the S5120-EI switch
supports only one IP precedence value in a rule. If you configure
multiple IP precedence values in a rule, the rule cannot be issued.
protocol protocol-name
Specifies to match the packets of a specified protocol. The
protocol-name argument can be IP or IPv6.
service-dot1p 8021p-list
Specifies to match packets by 802.1p precedence of the service
provider network. The 8021p-list argument is a list of CoS values
in the range of 0 to 7.
Even though you can provide up to eight space-separated CoS
values for this argument, the S5120-EI switch supports only one
CoS value in a rule. If you configure multiple CoS values in a rule,
the rule cannot be issued.
service-vlan-id vlan-id-list
Specifies to match the packets of the VLANs of the operator’s
network. The vlan-id-list argument is a list of VLAN IDs, in the form
of vlan-id to vlan-id or multiple discontinuous VLAN IDs
(separated by space). You can specify up to eight VLAN IDs for
this argument at a time. VLAN ID is in the range of 1 to 4094.
In a class configured with the operator and, the logical relationship
between the service VLAN IDs specified for the service-vlan-id
keyword is or.
source-mac mac-address
Specifies to match the packets with a specified source MAC
address.
Suppose the logical relationship between classification rules is and. Note the following when using the
if-match command to define matching rules.
z If multiple matching rules with the acl or acl ipv6 keyword specified are defined in a class, the
actual logical relationship between these rules is or when the policy is applied.
z If multiple matching rules with the customer-vlan-id or service-vlan-id keyword specified are
defined in a class, the actual logical relationship between these rules is or.