Harmonic ProView 7000 - Refreshing the EMS Screen

Chapter 4 Element Management System (EMS) Refreshing the EMS Screen
© 2011 Harmonic Inc. 143 ProView 7000 v.2.4, Rev. A
6. Click OK to confirm the decoding set-up.
4.7 Refreshing the EMS Screen
The EMS supports a user-driven screen refresh function. This function can refresh the
following:
■ Element – Updates a branch or specific element in the stream, either at the multiplexed
input or the multiplexed output.
■ Device – Updates the currently managed ProView 7000 device.
To refresh an element or device:
1. Select an element or device.
2. Select File > Refresh > [device|element]
—or—
click Refresh on the EMS Toolbar.
You can also perform a refresh by right-clicking the element icon and selecting the Refresh
item in the displayed element drop-down menu.