Harmonic ProView 7000 - Page 159

Chapter 5 Front Panel Interface Front Panel Root Menu
© 2011 Harmonic Inc. 159 ProView 7000 v.2.4, Rev. A
5.2.2.3 Service Selection Mode Menu
Use this menu to select a service selection mode.
To access the Service Selection Mode menu:
❖ Navigate Root > 2 Decoding > 1 Configuration > Service Selection Mode.
The Service Selection Mode menu contains the following radio buttons:
■ Automatic Mode – Use this mode for ProView 7000 to automatically decode the first
program in the TS (first PMT).
■ Program selection – Use this mode to set the decoder to manual program selection.
■ PID Selection – Use this mode to set the decoder to manual PID selection.
■ No Decoding – Use this mode to disable decoding.
Descrambling Menu
❖ To access the Descrambling menu, navigate
Root > 2 Decoding > 1 Configuration > Descrambling.
The Descrambling menu contains the following menu:
■ CAM Selection – This menu item presents a new screen with the following radio buttons
for selecting a CAM slot:
❑ CAM 1
❑ CAM 2
❑ None
Service Selection Mode
1 ƒ Automatic Mode
2 ‚ Program selection
3 ‚ PID Selection
4 ‚ No Decoding
Descrambling
1 CAM Selection
None