Harmonic ProView 7000 - Page 190

Appendix D ProView 7000 Alarm List
© 2011 Harmonic Inc. 190 ProView 7000 v.2.4, Rev. A
No PCR detected
Warning
This may cause AV sync issues.
Check the PCR PID configuration.
Normal stream while
configured to low delay
Warning
Configure the decoder buffer management mode to Normal
Delay.
Packet Loss Detected
After CAM
Major
Packets were dropped by the CAM.
Verify:
■ The input bitrate does not exceed the CAM limit
■ The CAM supports the number of descrambled programs.
■ If the problem persists please contact your CAM vendor.
PER Too High
Warning
Verify reception conditions and wiring.
Program Descrambling
Failure (output,
Program #)
Major
Verify that the number of programs descrambled is supported by
the CAM or contact your CAM vendor.
Regional feed precedes
national feed
Major
Check that the configuration is correct and consider increasing
the regional feed delay.
Voltage Error
Critical
Contact Harmonic’s help desk.
Table D–1: ProView 7000 Alarms
Description Severity Corrective Action