HONDA
CBLCOOT
CRANKSHAFTIBALANCER
-7
BEARING INSPECTION
CONNECTING RODS
Inspect the bearing inserts for damage, separa-
-.
tion, or other defects.
Put a piece of plastigauge on each crankpin,
avoiding the oil hole.
Install the bearing caps on the correct crank.
pins, and torque them evenly.
SPECIFIED TORQUE:
2.5-2.9
kg-m
(18-21
lbs-ft)
NOTE
Do not rotate crankshaft during inspec-
tion.
2.5-2.9 kg-m (18-21
I!&&)
-.
Remove the caps and measure the compressed
plastigauge on each crankpin.
OIL CLEARANCE SERVICE LIMIT:
0.08
mm
(0.003
in.)
Date of Issue: September, 1977
o
HONDA
MOTOR
co.,
LTD.
10-9
To Next Page
Loading...
