HONDA
CB400T
FRONT
WHEEL
/BRAKE
/
1
2.
SUSPENSION
INSTRUMENTS
HANDLEBAR
7
12-4
FRONT FORK
12-5
STEERING STEM
SERVICE INFORMATION 12-1 FRONT WHEEL
REMOVAL/
DISASSEMBLY/ASSEMBLY 12-6
TROUBLESHOOTING 12-2
FRONT BRAKE PANEL
12-10
HEADLIGHT 12-3
FRONT WHEEL INSTALLATION 12-11
SERVICE INFORMATION
WORKING PRACTICE
Do not remove rivets, nuts and pins from the rim, spoke plate and hub, since they cannot
be
disassembled
Never ride on the spokes or try to bend the wheel.
Avoid damaging the aluminum alloy rim.
SPECIAL TOOLSICOMMON TOOLS
Special Tools
HOLLOW SET WRENCH
(6 mm)
BALL RACE DRIVER (BOTTOM)
BALL RACE DRIVER (TOP)
BALL RACE REMOVER
Common Tools
PIN SPANNER
LOCK NUT WRENCH SOCKET (32
x
30 cm)
EXTENSION BAR
BEARING DRIVER HANDLE (A)
BEARING DRIVER OUTER
(42
x
47
mm)
BEARING DRIVER PILOT (15mm)
FRONT FORKOILSEAL DRIVER BODY
FRONT FORK OIL SEAL ATTACHMENT
(13)
SPECIFICATIONS
Front wheel rim runout
Front fork tube bend
Date
of
Issue: September,
1977
O
HONDA MOTOR CO., LTD.
To Next Page
Loading...
