HONDA
FRONT WHEELIBRAKEISUSPENSION
@
CB400T
FRONT WHEEL REMOVAL/
BISASSEMLY/ASSEMBLY
FRONT WHEEL REMOVAL
Raise the front wheel off the ground by
placing a block or safety stand under the
engine.
Disconnect the speedometer cable from the
speedometer gearbox.
Disconnect the front brake cable. (Drum type
only)
Remove the front brake torque link. (Drum
type only).
Remove the cotter pin and loosen the axle
nut.
Remove the axle holder from the fork end.
Withdraw
the axle and remove the wheel.
after removing the front wheel. To do
so will cause difficulty in fitting the
brake disc between the brake pads.
Date of
Issue: September,
1977
@3
HONDA MOTOR CO., LTD.
To Next Page
Loading...
