3
HONDA
IGNITION
SYSTEM
@
CB4OOT
C.
D.
I.
UNIT
INSPECTION
Disconnect wiring. Set the tester at
xkS2 or
xlQ0i2 and check continuity of
C.D.1.
terminals. Replace the C.D.I. unit if the
readings do not fall within the limits shown in
the table.
NOTE
The C.D.I. unit
is
fully transistorized.
For accurate testing,
it
is necessary
to use a specified electrical tester.
Use of an improper tester or measure-
ments in improper range may give
false readings.
.
Use SANWA ELECTRICAL TESTER
(SP-1OD) PIN 07308-0020000 or
KOWA ELECTRICAL TESTER
(TH-
5H).
1.
Discharge the capacitor before
/
testing.
1.
"NEEDLE SWINGS AND RE-
I
TURNS" indicates that
a
capacitor
is
being charged with the tester. The
tester needle will stay
at
infinity in
subsequent tests unless the capaci-
tor
1s
discharged.
UPPER ROW: MEASURING RANGE
(SANWATESTER) xkS2
LOWER ROW: MEASURING RANGE
(KOWATESTER) x100.Q
The resistances shown in the table indicate
those to be read on the tester, not of specific
circuits or parts.
he
Snerifications
in
Fia.
1
are a~~licable to (Fis.
1)
,
-r.-...--.
-~
. .
the C.D.I. unit (connectors on the blue and
white wires) used on following models:
'1.'
:
Needle swings and back to
-.
..
16-4
Date of kue: December, 1980
Q
HONDA MOTOR CO., LTD.
To Next Page
Loading...
