Honeywell H-S81-HS User Manual

146 H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
Operating Instructions Event Displaying
7.10.5 Change Password
This option allows to change user passwords. First of all, select the access level for password
changing. After selecting the desired level, the screen shown in the following picture will be dis-
played:
In this stage, the new password has to be entered twice. It shall include 5 numbers followed by
Enter. For safety reasons, entered numbers will be shown as #.
7.11 Event Displaying
Below you will find the description of how events are displayed during the various operating stages
of the control panel.
Initialization Cycle
It is run upon system start and after Area/Zone transfer through the program Pro-S81.
The initialization cycle includes the following stages:
Hardware Verification
The main CPU checks secondary CPU and Display module operation.
Module Verification
The main CPU checks that bus modules operate properly and are correct.
Module Software Version Verification
The main CPU checks the compatibility between software version and configured modules.
Module Initialization
The main CPU sends the configuration parameters of all programmed devices to each module.
Module Enable
The main CPU enables module operation.
Clock Synchronization
The main CPU synchronizes system clock to check time slot status.
Figure 7.23 Change Password

Honeywell H-S81-HS Specifications

General

Brand	Honeywell
Model	H-S81-HS
Category	Control Panel
Language	English