Honeywell H-S81-HS - OPC Server; Programming

H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015 25
OPC Server General Description
1.8 OPC Server
Thanks to the program OPC Server, any Windows OPC Client applications (Scada/DCS, supervi-
sors, control or other applications) can communicate to H-S81-HS series control panels featuring
V2.0.0 or higher software version. The OPC Client application can interact with all variables made
available by the control panel following the modes defined by the OPC standard. By using the pro-
gram OPC Server, clients can access the following data:
•Alarms
• Analog value measurements
• Device status indications
• Control panel status indications
• Communication status indications
For using the program OPC Server, please refer to the specific manual ST-057-IT.
1.9 Programming
H-S81-HS system programming is carried out through a personal computer in OFF-LINE mode by
means of a specific configuration program. After completing the configuration and checking that
the entered data are correct, data can be transferred to the central unit. Once they have been trans-
ferred, the central unit replaces the old configuration with the new one and re-initializes the system.
If there are two CPUs, the configuration is transferred to both at the same time. For using the con-
figuration program Pro-S81, please refer to the specific manual ST-015-IT.
Figure 1.10 Example of Connection with OPC Server